Effects of physical guidance on short-term learning of walking on a narrow beam☆
Received 11 February 2009; received in revised form 19 June 2009; accepted 3 July 2009. published online 13 August 2009.
Abstract
Physical guidance is often used in rehabilitation when teaching patients to re-learn movements. However, the effects of guidance on motor learning of complex skills, such as walking balance, are not clear. We tested four groups of healthy subjects that practiced walking on a narrow (1.27cm) or wide (2.5cm) treadmill-mounted balance beam, with or without physical guidance. Assistance was given by springs attached to a hip belt that applied restoring forces towards beam center. Subjects were evaluated while walking unassisted before and after training by calculating the number of times subjects stepped off of the beam per minute of successful walking on the beam (Failures per Minute). Subjects in Unassisted groups had greater performance improvements in walking balance from pre to post compared to subjects in Assisted groups. During training, Unassisted groups had more Failures per Minute than Assisted groups. Performance improvements were smaller in Narrow Beam groups than in Wide Beam groups. The Unassisted-Wide and Assisted-Narrow groups had similar Failures per Minute during training, but the Unassisted-Wide group had much greater performance gains after training. These results suggest that physical assistance can hinder motor learning of walking balance, assistance appears less detrimental for more difficult tasks, and task-specific dynamics are important to learning independent of error experience.
aSchool of Kinesiology, University of Michigan, Ann Arbor, MI, USA
bDepartment of Biomedical Engineering, University of Michigan, Ann Arbor, MI, USA
Corresponding author at: School of Kinesiology, 401 Washtenaw Avenue, Ann Arbor, MI 48109-2214, USA. Tel.: +1 734 647 3871; fax: +1 734 936 1925.
☆ A portion of the data presented in this study was also published as an abstract in the Proceedings of the North American Congress on Biomechanics, August 5–9, 2008, Ann Arbor, MI, USA.